基于石英基片的二毫米波段分谐波混频器设计和研制
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Design and fabrication of a 2 mm-band sub-harmonic mixer based on quartz
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    介绍了一种基于石英基片的2mm波段二次谐波混频器.阐述了谐波混频器的基本原理, 建立了混频二极管对结构的高频模型, 并用全波分析软件对整个电路进行了仿真优化.实测得到射频信号在116~120GHz范围内, 当本振频率为59GHz、功率为7~14dBm时, 最低变频损耗为17dB, 最高变频损耗为20dB.混频器的P1dB为1dBm, 各端口隔离度均优于20dB.研制的集成2mm波段二次谐波混频器实测结果与设计结果吻合较好.

    Abstract:

    An integrated 2mm band sub-harmonic mixer based on quartz circuits was presented. General harmonic mixer theory was introduced. The equivalent circuit model for the anti-pair diodes was built. Then the extensive simulation and optimization by the full wave analysis software were done. When the 59GHz LO signal’s power was set between 7~14dBm, the mixer yielded a least conversion loss of 17dB and a maximum loss less than 20dB under working frequency of 116~120GHz. The P1dB of the mixer is about 1dBm. The isolation between the three ports is better than 20dB.The measured results of the sub-harmonic mixer are agreed well with the simulated ones.

    参考文献
    相似文献
    引证文献
引用本文

安大伟,于伟华,吕昕.基于石英基片的二毫米波段分谐波混频器设计和研制[J].红外与毫米波学报,2011,30(1):33~37]. AN Da-Wei, YU Wei-Hua, LV Xin. Design and fabrication of a 2 mm-band sub-harmonic mixer based on quartz[J]. J. Infrared Millim. Waves,2011,30(1):33~37.]

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2010-03-01
  • 最后修改日期:2010-07-01
  • 录用日期:2010-07-05
  • 在线发布日期: 2011-02-24
  • 出版日期: