高效率曲折槽波导毫米波行波管设计、制造和冷测
作者:
作者单位:

1.电子与信息工程学院,深圳大学,广东 深圳 518000;2.电子科学与工程学院,电子科技大学,四川 成都 610054;3.中国电科思仪科技股份有限公司,山东 青岛 266400;4.南京三乐电子信息产业集团有限公司,江苏 南京 210008

作者简介:

通讯作者:

中图分类号:

TN124

基金项目:


Design, fabrication and cold test of a high efficiency folded groove waveguide for w-band sheet beam TWT
Author:
Affiliation:

1.Free Electron Terahertz and Nanobeam Laboratory Shenzhen University, Shenzhen 518000, China;2.School of Electronic Science and Engineering, University of Electronic Science and Technology of China, Chengdu 610054, China;3.Ceyear Technologies Co., Ltd, Qingdao 266400, China;4.Nanjing Sanle Electronic Group Co., Ltd; Nanjing 210008, China

Fund Project:

Supported by the National Natural Science Foundation of China (62001297, 61921002 and 61988102) and Shenzhen Science and technology (JCYJ 2020019105415835 and KQTD 20200820113046084)

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    本文提出一种适用于工作在毫米波段(85~110 GHz)的带状注高效率曲折槽波导毫米波行波管,并进行了参数优化设计、加工制造和冷测实验研究。曲折槽波导首次采用一次改变周期相速跳变技术提高带状注毫米波行波管电子互作用效率。文中加工制造了三种不同周期个数(包含相速跳变和均匀相速两种类型)的曲折槽波导,并进行了S参数测试,其结果表明应用一次相速跳变技术的曲折槽波导具有良好的传输特性和较宽的带宽。此外,通过测量三种不同周期个数曲折槽波导的相位传输得到了不同周期p0和p1的色散曲线,其结果证明通过仿真得到的色散曲线和测量得到的色散曲线相吻合。文中注波互作用三维粒子模拟结果表明:当曲折槽波导慢波结构末端20个半周期采用一次相速跳变技术时,在频点95 GHz处输出饱和功率达到240 W,比同等条件下的均匀相速曲折槽波导行波管在95 GHz处高70 W。同时,曲折槽波导行波管采用一次相速跳变技术在频带85~110 GHz范围内电子效率明显得到提高,并且在95 GHz处最大电子效率提高了47%。

    Abstract:

    In this paper, a design, fabrication and cold test of a high efficiency folded groove waveguide (FGW) for w-band (85~110GHz) sheet beam traveling wave tube (TWT) is proposed. One stage phase velocity taper (OSPVT) was used in the FGW to enhance the electronic efficiency of a millimeter-wave sheet beam TWT. The OSPVT was realized via a change of the period of the FGW. Three FGWs with and without OSPVT were fabricated and their measured s-parameters demonstrate good transmission characteristics and wide bandwidth. Moreover, wave dispersions and phase velocities of the unchanged and OSPVT FGWs were obtained from measured transmission phases. 3-D particle-in-cell simulations of beam-wave interaction predicted that the proposed TWT with an OSPVT of twenty half periods could output a saturated power of 240 W at 95 GHz, which is about 70 W higher than the case of without OSPVT. Meanwhile, the application of the OSPVT improves the electronic efficiency in the whole operating frequency range of 85~110 GHz, with a maximum efficiency enhancement of about 47% in the vicinity of 95 GHz.

    参考文献
    相似文献
    引证文献
引用本文

田艳艳,王禾欣,石先宝,李新义,宫玉彬,何文龙.高效率曲折槽波导毫米波行波管设计、制造和冷测[J].红外与毫米波学报,2022,41(1):311~316]. TIAN Yan-Yan, WANG He-Xin, SHI Xian-Bao, LI Xin-Yi, GONG Yu-Bin, HE Wen-Long. Design, fabrication and cold test of a high efficiency folded groove waveguide for w-band sheet beam TWT[J]. J. Infrared Millim. Waves,2022,41(1):311~316.]

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2021-07-09
  • 最后修改日期:2022-01-18
  • 录用日期:2021-08-09
  • 在线发布日期: 2022-01-17
  • 出版日期: