首页 | 杂志简介 | 征稿简则 | 投稿指南 | 常见问题 | 名词解释 | 刊物订阅 | 联系我们 | English
512×8元双波段TDI红外探测器的低噪声成像电路设计
投稿时间:2016-12-12  最后修改时间:2016-12-21  点此下载全文
引用本文:李锋,董峰,冯旗.512×8元双波段TDI红外探测器的低噪声成像电路设计[J].红外,2017,38(2):11~20
摘要点击次数: 70
全文下载次数: 59
作者单位E-mail
李锋 中国科学院上海技术物理研究所 lifengsitp@163.com 
董峰 中国科学院上海技术物理研究所  
冯旗 中国科学院上海技术物理研究所  
中文摘要:设计了一种基于512×8元双波段TDI红外 焦平面探测器的低噪声实时成像数据采集系统。根据器件内 部的电路结构以及输出模拟信号的特点,设计了一种由偏置电压、驱 动电路、模数转换电路和数字信号处理模块等组成的低噪 声采集电路。经噪声测试可知,在26℃的室温下,电路噪 声为0.02~0.18 mV;当积分时间为300 μs时,短波红外和中波红外探测 器各个像元的噪声电压分别为2.5~4.5 mV和8~10 mV,其 各个像元的信噪比分别为52~57 dB和43~48 dB。结果表明,该系统具 有良好的噪声特性,可以满足实际的工程应用需求。
中文关键词:512×8  中波红外  低噪声  采集系统
 
Design of the Acquisition System with Low Noise Based on 512×8 Dual Band TDI IRFPA
Abstract:A low noise real-time imaging data acquisition system based on a 512×8 dual band TDI IRFPA is designed. According to the characteristics of internal circuits and output analog signals, a low noise collection circuit composed of bias voltage, drive circuit, A/D conversion circuit and digital signal processing module etc is designed. It is found in the noise test that at the room temperature of 26 ℃, the noise of the circuit is 0.02 mV to 0.18 mV. For the integration time of 300 μs, the noise voltage of each shortwave infrared detector element and that of each mid-wave infrared detector element are 2.5 mV to 4.5 mV and 8 mV to 10 mV respectively. Their signal-to noise ratios are 52 dB to 57 dB and 43 dB to 48 dB respectively. The test results show that the system has good noise characteristics and can meet the requirements of practical engineering application.
keywords:512×8  dual band  low noise  acquisition system
查看全文  查看/发表评论  下载PDF阅读器

版权所有:《红外》编辑部

北京勤云科技发展有限公司